Microscopic Board Level Repair
ZXW no longer requires the dongle. Please see our instructions on how to install version 3.x! https://www.microsoldering.com/how-to-setup-and-install-zxw-tools-v3-x/ So, you recently purchased ZXW Tools from our online store or Amazon and have no clue how to set it up? Well, here’s a quick guide detailing the installation process. Step 1 Unbox the ZXW tools dongle and plug…
Read More “How to Setup and Install ZXW Tools Dongle v2.x” »
The usual suspect for a backlight blowing out on an iPad Pro 9.7 is not disconnecting the battery before a screen repair. It’s imperative to isolate the battery before lifting the screen connectors from the logic board because even when the ipad is powered off, there is power going to the backlight pin on the…
Problem: You have an iPhone 6 where the wifi signal is very weak. It works when you are close to the router, but as you get further away, the signal goes away. Solution: First off, check to make sure that the wifi antenna did not come lose. That is the first step. This wifi antenna…
Read More “iPhone 6 Weak Wifi Signal Problem and Solution” »
Another common problem that we’ve been seeing is no touch on an iPhone 6S Plus after a screen repair. The screen works, the phone vibrates, everything else looks like it works fine, but the touch doesn’t work. Well, the problem is that there is a row of components right below the lcd/digitizer connector that is…